Configuring ig04 bacnet gateway with fusionlive, System tab – Innotech IG04 BACnet Gateway User Manual

Page 16

Advertising
background image

Installation Instructions for Innotech IG04 BACnet Gateway and Vaisala Transmitter / Sensor

Page 16

© Mass Electronics Pty Ltd 2011

Edition 5.0 dated 11/11/2013

Configuring IG04 BACnet Gateway with FusionLIVE

When you have accessed the FusionLIVE Java application by following the instructions described in

the

Accessing Embedded Server and FusionLIVE

section, you can modify the configuration settings of

the IG04 BACnet Gateway by clicking on the

button from the FusionLIVE window.

The Configure Innotech IG04 BACnet Gateway Settings window will be displayed with different tabbed

options you can select to configure the IG04 BACnet Gateway. Each of these tabs is described in detail

in the subsequent sections.

It is recommended that the Ethernet settings be configured as the last step since this will require you

to modify the TCP/IP address of your computer to be on the same network range as the IG04 BACnet

Gateway in order to access the embedded web server.

System Tab

Under the System tab you can configure or modify the following settings:

• BACnet device name

• Device password

There is no password configured by default, but if a password is configured then you can only view

the data; you cannot make any changes. In cases where you forget the configured password, you will

need to contact Innotech to reset your password. Contact details are shown on the last page of this

document.

To configure or change the password, enter the current password, and then enter the new password.

Click on

Change Password to save the new password. If you modify the device name, click on Apply

to save your current settings, as illustrated in Figure 12 below.

Figure 12: Configure IG04 settings in FusionLIVE – System Tab

Advertising