Innotech IG04 BACnet Gateway - Manual (Page 17)

Installation Instructions for Innotech IG04 BACnet Gateway and Vaisala Transmitter / Sensor
Page 17 © Mass Electronics Pty Ltd 2011 Edition 5.0 dated 11/11/2013
BACnet Tab
Under the BACnet tab you can configure or modify the following settings:
• BACnet Instance number
• BACnet Datalink protocol
• BACnet MS/TP Settings
Please note that the MS/TP settings can only be modified if the BACnet Datalink is selected as MSTP.
Otherwise these settings cannot be modified and will be unaccessible.
It is recommended to leave these settings at the default values, as illustrated in Figure 13 below.
NOTE
The default BACnet Instance number for the IG04 BACnet Gateway is 1509.
NOTE
Figure 13: Configure IG04 settings in FusionLIVE – BACnet tab