ADC AVIDIA SWD4573I1 - Manual (Page 178)

Configuring DS3 Service
152 Avidia System Configuration and Management User Manual
Circuit Identifier A text string that identifies the circuit. This feature is not yet
supported.
Cell Scrambling Indicates whether cell scrambling is enabled or disabled.
Framing Mode The mode used to map ATM cells to frames. Options:
• direct—maps cells directly
• plcp—uses the ATM Physical Layer Convergence Protocol
(PLCP)
Line Status The status of the line interface. Options:
• dsx3NoAlarm—No alarms are present.
• dsx3RcvRAIFailure—Receiving a remote alarm indication.
• dsx3XmitRAIAlarm—Transmitting a remote alarm
indication.
• dsx3RcvAIS—Receiving an AIS.
• dsx3XmitAIS—Transmitting an AIS.
• dsx3LOF—Receiving a loss-of-frame error.
• dsx3LOS—Receiving a loss-of-signal error.
Transmit Clock Source The type of timing in use. Options:
• LoopTiming
• LocalTiming
Invalid Intervals The Avidia system does not have invalid intervals, therefore 0
displays.
LBO The length of the line. Options:
• 0 to 225 feet (69 m)
• More than 225 feet
Last Line Status Change The time and date of the last line status change.
Line Status Change Trap
Enable Indicates whether DS3 trap generation is enabled or disabled.
Loop Back Status Loopbacks are not yet supported, therefore dsx3NoLoopback
displays.
Channelization This feature is currently disabled, therefore Disabled displays.
DS1 For Remote Loop Indicates which DS1 will be looped back. A value of 0 means
no DS1 will be looped. A value of 29 means all DS1s will be
looped.
Admin Status The configured admin status of the line, either Up or Down.
Information Descriptions