ADC AVIDIA SWD4573I1 - Manual (Page 274)

Configuring System Bridging Parameters
248 Avidia System Configuration and Management User Manual
Modifying System Bridging Parameters
From the ::bridging=> prompt, type the modify command in the following format, then
press .
modify [-brenable (on|off)] [-wanbcenable (on|off)] [-age <sec>]
Parameters
[-brenable (on|off)]
Type -brenable on to enable bridging. Type -brenable off to disable bridging.
[-wanbcenable (on|off)]
Determines whether unknown WAN frames are broadcast to all WAN logical interfaces.
Type
-wanbcenable on to enable WAN broadcasting. Type -wanbcenable off
to disable WAN broadcasting.
[-age <sec>]
Specifies the interval, in seconds, after which Bridging Table entries are deleted if they are
not relearned. The valid range is 10 - 1000000. The default is 300 seconds.
Displaying System Bridging Parameters
To verify system bridging configuration, from the ::bridge=> prompt, type show then press
. A screen similar to the following displays.
ENTER
ENTER
::bridge=> show
Bridging Enabled : enabled(1)
WAN Broadcast Enabled : enabled(1)
Aging Time (sec) : 300