Great Plains Auto Reset Bolt Retainer - Manual

© Copyright 2004 Printed
Great Plains Mfg., Inc.
Used with:
Installation Instructions
598-026M
Auto Reset Shank
Auto Reset Bolt Retainer
• Auto Reset Shank
General Information
When you see this symbol, the subsequent instructions and
warnings are serious - follow without exception. Your life and
the lives of others depend on it!
!!
These instructions explain how to install the Auto
Reset Bolt Retainer. A retaining lock to keep auto
reset bolts from turning loose.
These instructions apply to:
598-025A Auto Reset Bolt Retainer
11/17/2004
Before You Start
Page 3 is a detailed listing of parts included in the
Auto Reset Bolt Retainer package. Use this list to
inventory parts received.
Tools Required
• Basic hand tools
Assembly Instructions
Refer to Figure 1
1. Raise the implement and install transport
locks. Place tractor in park, turn off ignition
and remove the key before performing up-
date.
2. Remove the rear 5/8" x 8" bolt (2) and 5/8"
lock nut from the rear spring channel (3).
Keep the bolt and nut for reuse.
NOTE: If the 5/8" bolt (2) is binding it will be nec-
essary to adjust the 1" bolts (4) in to relieve pres-
sure on bolt (2).
!
DANGER!
Do Not drive or force bolt (2) out. The stored energy of
the springs could cause damage or bodily injury when
released. Use bolts (4) to relieve pressure on bolt (2).
3. Place a block (1) under the spring to support
the springs.
4. Unscrew the 1" x 14" bolts (4) evenly from the
springs and remove leaving the spring chan-
nel (3) in place. Keep the bolts.
Figure 1
Remove Bolts
22808