Great Plains Shank Holder Clamp Bolt Update User Manual
Assembly instructions, Shank holder clamp bolt update, 023a shank holder bolt field update
© Copyright 2004 Printed
Great Plains Mfg., Inc.
Used with:
Installation Instructions
598-024M
2003 and 2004
Inline Ripper and Verti-Till Ripper
Shank Holder Clamp Bolt Update
• 3-8 Shank Inline Ripper
(Rigid mount shanks only)
• 5, 7 & 9 Shank Verti-Till Ripper
(Rigid mount shanks only)
When you see this symbol, the subsequent instructions and
warnings are serious - follow without exception. Your life and
the lives of others depend on it!
!!
Assembly Instructions
Refer to Figure 1
1.
Remove, one at a time, the existing shank
holder clamp bolts and nuts.
2.
Replace with a 3/4" x 6" GR8 bolts (1), 3/4"
hardened flat washers (2), 3/4" lock washers
(3) and 3/4" nuts (4).
3.
Place two flat washers (2) against the head of
the bolt (1) and one flat washer (2) next to the
lock washer (3).
NOTE: Extra hardened washers allows use of
longer bolt to keep threads out of shear area.
4.
Torque bolts (1) to 400 FT LBS.
IMPORTANT! Torque bolts to 400 FT LbS.
5.
Re-torque bolts to 400 FT LBS after one hour
of operation and again after five hours of op-
eration.
6.
Re-torque bolts periodically to 400 FT LBS.
10/26/2004
2
802-478C
HHCS 3/4-10 X 6 GR8
2
803-027C
NUT HEX 3/4-10 PLT
2
804-023C
WASHER LOCK SPRING 3/4 PLT
6
804-093C
WASHER FLAT 3/4 HARD ASTMF 436
Qty.
Part No.
Part Description
598-023A Shank Holder Bolt Field Update
Your kit includes:
Figure 1
22743