AMETEK BPS Series Programming Manual - Manual (Page 13)

BPS / MX / RS Series SCPI Programming Manual AMETEK Programmable Power
Manual P/N 7003-961 Rev. AA 13
1.5.4 RS232C Capabilities of the AC source
All AC source functions are programmable over the RS232C interface. The RS232C
capabilities of the AC source are listed in Chapter 2 of the User's Manual. Some capabilities
support on the GPIB interface such as ATN, GET and SRQ interrupts do not apply to the
RS232C interface. Baudrates from 9600 to 115200 are supported on units that have both
USB and RS232. For units with only RS232, the maximum baudrate is 38400.
To set up the RS232C interface, refer to section 3.3, “RS232C Interface”.
The RS232C interface may be used to install updated firmware for the controller if needed.
Firmware updates and a Flash Loader utility program and instructions are available from the
AMETEK Programmable Power website for this purpose. (
www.programmablepower.com )