AMETEK BPS Series Programming Manual - Manual (Page 190)

AMETEK Programmable Power BPS / MX / RS Series SCPI Programming Manual
190 Manual P/N 7003-961 Rev AA
8.4 RTCA/DO-160D (-160)
The following are the remote commands set for DO-160D. ABORt command will terminate
the test in progress at any time. See the MX Series User Manual (P/N 7003-960) or RS
Series User Manual (P/N M440036) for more details about each 160 test step.
Note that revisions E and F of the DO160 tests are implemented in the MXGui Windows
software provided with the power source. These revisions cannot be run without the MXGui
and don’t have an associated set of SCPI commands. The commands listed in this section
apply to the firmware-based revision D only. For information on revision E and F, refer to the
Avionics Software Manual, P/N 4994-971 provided on the same CD as this manual.
DO160
:NORMal
:VOLT_FREQ
:MINinum
:MAXimum
:VOLTage
UNBalance
:WAVeform
:DISTortion
:VOLTage
:MODulation
<numeric>
:INTerrupt <numeric>
:SURG
:DC
:UNDer
:FREQency
:MODulation
<numeric>
:TRANSient
:VARiation
:EMERgency
:VOLT_FREQ
:MINimum
:MAXimum
:VOLTage
:UNBalance
:ABNormal
stage
:VOLTage
:MINimum
:MAXimum
:UNDer
:OVER
:DC
:LOW
:FREQuency
:TRANsient
:CATegory
:STANdard
:GROup