Baby Lock Palette 10 (ECS10) Instruction Manual - Manual (Page 174)

173
On Using the Cutwork Functions
On Using the Cutwork Functions
Before using Cutwork functions, check the following.
■ Set the "Machine Type" to multi-
needle embroidery machine
For the Cutwork functions to be available, click ,
then [Design Settings]. Under [Machine Type],
select .
■ Outline shapes and text can be
used to create a cutwork pattern
• Outline shapes that have been drawn with the
tools indicated below.
• Text created in fonts other than built-in fonts 025
and 029, a user-defined font or a small text font.
• Patterns when [Outline Shapes] is selected in
the [From] selector of the [Import] pane.
■ Use a multi-needle machine that
has been upgraded to work with
Cutwork functions
The embroidery machine should be set to cutwork
mode in the settings screen before starting to
embroider. Refer to the included Operation Manual
for the details of embroidery machine operation.
Basic requirements for
Cutwork functions
a
Cutwork functions cannot be used with single-
needle embroidery machines. In addition, some
multi-needle machines may not support the
functions. Be sure to check that your machine is
compatible with the cutwork functions.