Comtech EF Data CDM-IP 300L - Manual (Page 133)

CDM-IP 300L IP-Centric Satellite Modem Rev. 1
CD/CDMIP300L.IOM
107
5.5 S
TATUS
C
OMMANDS
/R
ESPONSES
5.5.1 M
ODULATOR
C
ONFIGURATION
S
TATUS
Parameter Type Protocol Description
Modulator
Config.
Status
Command:
Response:
<add/MCS_'cr'
>add/MCS_'cr'
RF_xxx'cr'
MF_nnn.nnnnnnn'cr'
MR_nnnn_mmmm.mmm'cr'
AMRA_nnnn_mmmm.mmm'cr'
AMRB_nnnn_mmmm.mmm'cr'
AMRC_nnnn_mmmm.mmm'cr'
AMRD_nnnn_mmmm.mmm'cr'
AMRV_nnnn_mmmm.mmm'cr'
MPO_snn.n'cr'
MOP_snn.n'cr'
SE_xxx'cr'
DENC_xxx'cr'
MT_xxxxx'cr'
MET_xxx'cr'
COM_xxxxxx'cr'
MRC_xxx'cr'
MSR_xxx'cr'
RSEN_xxx'cr'
TDA_xxx'cr'
TRSI_xx'cr'
T310_xxx'cr''lf']
RF Output
Modulator Frequency
Modulator Rate
Preset 'A' Assignment
Preset 'B' Assignment
Preset 'C' Assignment
Preset 'D' Assignment
Preset 'V' Assignment
Modulator Power Offset
Modulator Output Power
Scrambler Enable
Differential Encoder
Modulator Type
Modulator Encoder Type
Carrier Only Mode
Modulator Reference Clock
Modulator Spectrum Rotation
Reed-Solomon Encoder
Transmit BPSK Data Ordering
TX Reed-Solomon Interleave Value
TX 8-PSK 2/3 IESS-310 Operation
The modulator configuration status command causes a block of
data to be returned by the addressed modem. The block of data
reflects the current configuration status of the modulator module.
Additional configuration status of new options and features will
always be appended to the end.
Modulator
Coder
Config.
Program
Status Command:
Response:
<add/MCP_'cr'
>add/MCP_'cr'
ITOT_xxxxx'cr'
MOM_xxxxxxx'cr'
MF_nnn.nnnnnn'cr'
MR_nnnn_mmmm.mmm'cr'
MPO_snn.n'cr'
MOP_snn.n'cr' (Note
4)
SE_xxx'cr'
DENC_xxx'cr'
MRC_xxx'cr'
MSR_xxx'cr'
RSEN_xxx'cr'
TDA_xxx'cr'
COM_xxxxxx'cr'
ODU_ xxx'cr'
ODUR_ xxx'cr'
ODUL_ xxxx'cr’
ODUH_ x'cr’
TRSI_xx'cr'
RF_xxx'cr''lf']
Interface Transmit Overhead Type
Modem Operation Mode
Modulator Frequency
Modulator Rate
Modulator Power Offset
Modulator Output Power
Scrambler Enable
Differential Encoder
Modulator Reference Clock
Modulator Spectrum Rotation
Reed-Solomon Encoder
Transmit BPSK Data Ordering
Carrier Only Mode
ODU (ON/OFF)
ODU Remote Mode
ODU Low Threshold
ODU High Threshold
TX Reed-Solomon Interleave Value
RF Output (ON/OFF)
Note:
This command is used by the EF Data M:N protection