Transmit and receive if configuration, If c, Cli) c – Comtech EF Data CDM-IP 300L User Manual
Page 334
CDM-IP 300L IP-Centric Satellite Modem
Rev. 1
CD/CDMIP300L.IOM
308
12.1.3 T
RANSMIT AND
R
ECEIVE
IF C
ONFIGURATION
Step Description
1
Configure the transmit and receive IF parameters on CDM-IP 1 and CDM-IP 2 via the
front panel.
Note: The IF parameters can also be set via console menu, Telnet, web interface and
SNMP - but for this exercise, it is recommended that the front panel be used.
2
Set the TxPower to minimum level.
3
Before proceeding to next step, make sure that each CDM-IP is appropriately carrier-
locked to the other CDM-IP.
12.1.4 S
ERIAL CONSOLE PORT
C
OMMAND
L
INE
I
NTERFACE
(CLI)
C
ONFIGURATION
Step Description
1
Launch the terminal emulation program - such as HyperTerminal on Microsoft Windows.
2
Select the appropriate COM port (to which the DB-9 end of the console cable is
connected) and configure it for:
38,400 bps
8 data bits
no parity
1 stop bit
no hardware flow control
3
Press return to bring up the Main menu.