Niveo Professional NGSME16T2H - Manual (Page 18)

Chapter 1: Product Overview
Product Overview
NGSME16T2H User Manual | 18
Hardware Installation
To install the Web Smart PoE Switch, please place it on a large flat surface with a
power socket close by. This surface should be clean, smooth, and level. Also, please
make sure that there is enough space around the PoE Switch for RJ45 cable, power
cord and ventilation.
If you’re installing this Web Smart PoE Switch on a 19-inch rack, please make sure
to use the rack-mount kit (L brackets) and screws come with the product package.
All screws must be fastened so the rack-mount kit and your product are tightly
conjoined before installing it on your 19-inch rack.
Ethernet cable Request
The wiring cable types are as below.
10 Base-T: 2-pair UTP/STP Cat. 3, 4, 5 cable, EIA/TIA-568 100-ohm (Max. 100m)
100 Base-TX: 2-pair UTP/STP Cat. 5 cable, EIA/TIA-568 100-ohm (Max. 100m)
1000 Base-T: 4-pair UTP/STP Cat. 5 cable, EIA/TIA-568 100-ohm (Max. 100m)
PoE: To delivery power without problem, the Cat 5e and Cat 6 cable is suggested.
The high quality Ethernet cable reduces the lost while power transmission.
SFP Installation
While install the SFP transceiver, make sure the SFP type of the 2 ends is the same
and the transmission distance, wavelength, fiber cable can meet your request. It is
suggested to purchase the SFP transceiver with the switch provider to avoid any
incompatible issue.
The way to connect the SFP transceiver is to Plug in SFP fiber transceiver fist. The
SFP transceiver has 2 plug for fiber cable, one is TX (transmit), the other is RX
(receive). Cross-connect the transmit channel at each end to the receive channel at
the opposite end.
For more information regarding to the product safety and maintenance guide, please
refer to Appendix A: Product Safety .