Yaskawa Σ-V Series AC Servo Drives Rotational Motor Analog Voltage Reference - Manual (Page 304)

10 Appendix
10.2.2 Parameters
10-22
Pn50C
2 Input Signal Selection 3 0000 to FFFF − 8888 After restart Setup −
(cont’d)
Parameter
No.
Size Name
Setting
Range
Units
Factory
Setting
When
Enabled
Classification
Reference
Section
/SPD-D Signal Mapping
(Refer to
5.6 Internal Set Speed Control .)
Reference
Section
0 Active when CN1-15 input signal is ON (low level).
5.6.1
1 Active when CN1-16 input signal is ON (low level).
2 Active when CN1-17 input signal is ON (low level).
3 Active when CN1-18 input signal is ON (low level).
4 Active when CN1-25 input signal is ON (low level).
5 Active when CN1-26 input signal is ON (low level).
6 Active when CN1-12 input signal is ON (low level).
7 Reserved (Do not change.)
8 Not active (fixed).
9 Active when CN1-15 input signal is OFF (high level).
A Active when CN1-16 input signal is OFF (high level).
B Active when CN1-17 input signal is OFF (high level).
C Active when CN1-18 input signal is OFF (high level).
D Active when CN1-25 input signal is OFF (high level).
E Active when CN1-26 input signal is OFF (high level).
F Active when CN1-12 input signal is OFF (high level).
/SPD-A Signal Mapping
(Refer to
5.6 Internal Set Speed Control .)
Reference
Section
0 to F Same as /SPD-D Signal Mapping. 5.6.1
/SPD-B Signal Mapping
(Refer to
5.6 Internal Set Speed Control .)
Reference
Section
0 to F Same as /SPD-D Signal Mapping. 5.6.1
/C-SEL Signal Mapping (Control method change when ON (L-level))
Reference
Section
0 to F Same as /SPD-D Signal Mapping. 5.7.1
4th 3rd 2nd 1st
digit digit digit digit
n.