Lanier LD 035 - Manual (Page 32)

Basic Procedure
17
2
Job Preset
You can set up the next copy content
during copying.
If a long copy job is in progress and
you do not want to wait for it to fin-
ish, you can use this function to set up
the next copy job in advance. When
the current copy job is finished, the
next job will start automatically.
AAAA
Press [Next Job] when "Copying" is
shown.
BBBB
Set up the next copy job.
CCCC
Place the originals in the ADF,
and then press the
{{{{Start}}}} key.
All originals are scanned.
DDDD
Press [To "Printing"].
Returns to the initial copy display.
After the current copy job, the next
job starts automatically.
Note
❒ You can switch the display to
the current copy job by pressing
[To "Printing"]
. You can switch
the display to the preset job by
pressing [To "Reserving"].
AdonisC3_GBcopyF_FM1.book Page 17 Thursday, November 28, 2002 1:53 PM