Lexicon 570 - Manual (Page 49)

44
Dancer Communications, Inc.
COMMAND>INP S
SET/CHECK INPUT SETTINGS
========= ===== ========
1 = Input #1 Outside Air
2 = Input #2 <Label>
3 = Input #3 <Label>
4 = Input #4 <Label>
5 = Input #5 <Label>
6 = Input #6 <Label>
7 = Input #7 <Label>
8 = Input #8 <Label>
0 = Previous Menu
Choose a Number>1
Input #1
PRESENT SETTINGS
======= ========
01 = Label Outside Air
02 = Sensor Type Temperature (°F)
03 = High Alarm Set Point 260
04 = Low Alarm Set Point -94
05 = Response Time 120 Sec.
06 = Output On Set Point 255
07 = Output Off Set Point -94
08 = Calibration Offset 2
09 = Data Logging Enabled
00 = Previous Menu
Choose a Number>9
Warning: Changing this option will reformat the data
logs, permanently
erasing all log data.
Data Logging for this input is Enabled.
Change Present State? [y/n]> No
Dry Contact Specific Parameters:
Input #1
PRESENT SETTINGS
======= ========
01 = Label Input #1
02 = Sensor Type Dry Contact
03 = Open Description ON
04 = Closed Description OFF
05 = Alarm Deselected
06 = Response Time 15 Sec.
07 = Output On Control Deselected
08 = Output Off Control Deselected
09 = Data Logging Enabled
00 = Previous Menu
Choose a Number>