Polycom SpectraLink 1725-36028-001 - Manual (Page 73)

15
Feature Programming
(no Softkeys)
If your system is utilizing any SpectraLink Wireless Telephones that
do not have softkeys (PT800 series or earlier),
Feature Programming is
used to allow these handsets to access system features.
Mute and optional OAI (Open Application Interface) must be
programmed in the
Feature Programming screen for both analog and
digital systems.
In digital systems, feature programming is done in the PBX. These
features are also programmed into the handsets according to the
directions outlined in the LinkPlus Interface Guide for your PBX.
In analog systems, the
Feature Programming screen is used to
program special features. With Feature Programming you can access
special features by pressing the
FCN key on the handset followed by
another key. This shortcut is called a “macro”. You may define
macros for the digits
1 - 9 , * , 0 , and # . After programming, when you
press FCN followed by a digit or character, you will have access to the
associated feature.
The feature programming settings are usually the same for every
SpectraLink 8000 Telephony Gateway. Note that the settings done on
one SpectraLink 8000 Telephony Gateway as described below should
be done on the rest of the SpectraLink 8000 Telephony Gateways
sharing the same PBX so that all handsets have access to the same
special features.
You must use this screen to program all analog features and to
program the
MUTE function to FCN 1 in all analog and digital
systems.
PN: 1725-36028-001_T.doc 73