Omega Vehicle Security OMP-MODL - Manual (Page 101)

5... H YPER C OMM ™ C OMMUNICATIONS
U SING THE OMP-MODL 5-14
After entry of the filename, a dialog will display for the User to enter
additional File Information to be stored with the file (Figure 5... -10).
This information includes a short single line Title as well as room for
extensive comments. The File Information can be accessed at a
later time from within the Post-Processing window and HyperPlot.
Upon closing of this dialog, the Download file will then be processed
and stored to disk as an ascii file with the extension *.HLD.
Data downloads can be performed while the logger is Enabled and
executing a Program Net that uses either of the Log to Full modes
(see the Global Icon in Appendix A). If the logger is in the Rotary
Memory mode, the unit must be Stopped before data can be
downloaded.
Refer to Chapter 7 for details on the Download of Data from the
PCMCIA card.
Probe Point Query
During the construction of a Program Net within HyperNet™, the
User can opt to connect Probe Point icons to various nodes
throughout the net. These Probe Point icons allow the User to view
the current values on the nodes to which they are connected. One
of the ways that the Probe Point values can be viewed is by clicking
and dragging the Probe Point icon overlaying the logger to the PC
and releasing it. The last updated value at the Probe Point node is
then displayed on the PC. Optionally, by clicking on the Resample
Periodically check box, readings will be communicated to the display
dialog as the node is updated.
Figure 5... -10: File Information comments entry dialog
Figure 5...
-11: Probe
Point icon