Omega Vehicle Security OMP-MODL - Manual (Page 93)

5... H YPER C OMM ™ C OMMUNICATIONS
U SING THE OMP-MODL 5-6
Phone:
A short dialing directory of frequently called logger numbers can be
maintained using the List Box provided.
ADDING A NEW D IRECTORY E NTRY :
To add a directory entry, use conventional text editing
commands to highlite then type over an existing entry. The entry
will not be lost and a new entry will be added.
The format for the directory entry consists of text followed by a
colon, then the phone number.
USER TEXT:619-555-1212
The phone number may contain numbers, hyphens, parenthesis
and commas with the following action:
♦
Numbers - digits 0 through 9 are dialed
♦
Hyphens and parenthesis - ignored during dialing
♦
Commas - insert a two second delay during dialing.
Delays may be required for accessing an outside line on
some phone systems.
E DITING AN EXISTING D IRECTORY E NTRY
Select the entry to be edited via the drop down list box. Using
the mouse, highlite the text to be edited and type in corrections.
R EMOVING D IRECTORY E NTRIES
The phone list is maintained within the hyperlog.ini file. This file
is located in the Windows directory and can be edited with any
text editor. Before editing this file, close the HyperWare
application and make a backup copy of the hyperlog.ini file in
case it needs to be restored. Two lines in the hyperlog.ini file
need to be deleted to properly remove a phone directory entry.
Follow these steps to remove the directory entry:
1. Close the HyperWare application.
2. Locate the hyperlog.ini file in the windows directory and
make a copy of it (eg hyperlog.bak)
3. Using Notepad, open hyperlog.ini
4. Locate the section titled [Modems]
5. Locate the line starting with PhoneX= where X is a
number and the entry to the right of the equal sign is the
entry to be removed.
6. Make a note of the value of X. Then delete the entire
line starting with PhoneX =
7. Locate and delete a second line with the same value of
X that starts with ModemX= which will be located in the
same section.
8. Save and Exit the editor. Re-launch HyperWare and
check that all is well.
Modem:
HyperComm includes the standard configurations for three major
modem brands, Hayes Compatible, US Robotics, and Zoom. Refer