LumaSense Technologies INNOVA 1316A-1 - Manual (Page 19)

Chapter 2
_________________________________________________________________________________________
_____________________________________________________________________________
BE6020-14 1316A-1 Multi Gas Monitor LumaSense Technologies A/S
Instruction Manual Page 19 of 98
be replaced at regular intervals to ensure that it still behaves
according to specification.
2.1.3 Mains Supply
Warning. The monitor must be used with protective earth.
The monitor operates in the AC voltage range from 100 – 240 V on a
single phase supply, 50 Hz – 60 Hz, 40 VA.
The power cable is connected to a socket on the rear panel. The on-
off switch is located immediately above this socket.
2.1.4 Checking and Changing the Fuses
On delivery ensure that the correct fuses are used. See section
5.1.2 .
2.2 The BZ 6012 Software
This software provides procedures to:
• Set-up and Calibrate the monitor prior to measuring
• Display measurement data as coloured graphics or numeric
values
• Store measurement data in a log file on the PC’s disk while
measurements are being made
• Control up to four Multi Gas Monitors INNOVA 1316A-1
The BZ6012 application can be installed by using the BZ6012
software CD-ROM.
2.2.1 Computer Requirements
The minimum requirements to run this software are:
Processor Minimum: 1 gigahertz (GHz) Pentium
processor