HP StorageWorks 2.32 Edge Switch - Manual (Page 165)

Edge Switch Element Manager user guide 165
Cannot add a switch to a zone. The device that you are attempting to
add to the zone is a switch, which
cannot be added to a zone. Specify the port number or corresponding
World Wide Name for the device you
want to add to the zone.
Cannot connect to management
server. The HAFM application at a remote
workstation could not connect to the
HAFM appliance. Verify the HAFM appliance internet
protocol (IP) address is valid.
Cannot delete product. The selected product cannot be
deleted. Verify the HAFM appliance-to-product link
is up.
If the link is up:
• The HAFM appliance may be busy.
• Another Element Manager instance
may be open.
• You may not have permission to delete
the product.
Cannot disable Fabric Binding
while Enterprise Fabric Mode is
active. You attempted to disable Fabric
Binding through the Fabric Binding
dialog box, but Enterprise Fabric
Mode was enabled. Disable Enterprise Fabric Mode through
the Enterprise Fabric Mode dialog box in
the HAFM application before disabling
Fabric Binding.
Cannot display route. All switches
in route must be managed by the
same server. You cannot show the route between
devices that are attached to switches
or directors managed by a different
HAFM appliance. Make sure devices named in Show Routes
dialog box are attached to products
managed by this HAFM appliance.
Cannot display route. All switches
in route must support routing. You cannot show the route through a
fabric that has switches or directors
which do not support routing. The route must contain only Edge Switch
2/16s, Edge Switch 2/32s, Director
2/64s, or Director 2/140s.
Cannot display route. Device is not
a member of a zone in the active
zone set. You cannot show the route for a
device that is not a member of a
zone in the active zone set. The
source node that you have selected is
not part of a zone in the active zone
set. Enable the default zone or activate the
zone for the device before attempting to
show the route.
Cannot display route on one switch
fabric. You cannot show routes between end
devices in a fabric when configuring
Show Routes (Configure menu). Error appears when attempting to show
routes on a fabric with only one switch.
Configure Show Routes on a multi-switch
fabric.
Cannot display route. error 9. An internal error has occurred while
trying to view routes. Contact the next level of support to report
the problem.
Table 7 HAFM messages (continued)
Message Description Action