HP StorageWorks 2.32 Edge Switch - Manual (Page 184)

Information and error messages 184
Enterprise Fabric Mode will be
disabled if any of the following
parameters are disabled: Insistent
Domain ID, Rerouting Delay,
Domain RSCNs. Do you want to
continue? You attempted to disable these
parameters in the Configure Switch
Parameters dialog box while the
switch was online, but Enterprise
Fabric Mode (SANtegrity Binding
feature) is enabled. Click Yes if you want to continue, and
disable Enterprise Fabric Mode.
Error retrieving port information. An error occurred at the Element
Manager while retrieving port
information because the Ethernet link
is down or busy. Retry the operation later. If the condition
persists, contact the next level of support.
Error retrieving port statistics. An error occurred at the Element
Manager while retrieving port
statistics because the Ethernet link is
down or busy. Retry the operation later. If the condition
persists, contact the next level of support.
Error stopping port diagnostics. An error occurred at the Element
Manager while attempting to stop
port diagnostics from running
because the Ethernet link is down or
busy. Retry the operation later. If the condition
persists, contact the next level of support.
Error transferring files
< message >. An error occurred while transferring
files from the PC hard drive to the
Element Manager. The message
varies, depending on the problem. Try the file transfer operation again. If the
problem persists, contact the next level of
support.
Feature not supported. The
‘product name’ must be running
version 05.00.00 or higher. The firmware version on the
hardware product (switch or director)
is lower than 05.00.00. This message
only appears if the optional Open
Trunking feature is installed. Install firmware version 5.00.00 or higher
on the hardware product.
Field cannot be blank. The data field requires an entry and
cannot be left blank. Enter appropriate information in the Data
field.
Field has exceeded maximum
number of characters. The maximum number of data entry
characters allowed in the field was
exceeded. Enter the information using the prescribed
number of characters.
File transfer aborted. You aborted the file transfer process. Information message only.
File transfer is in progress. A firmware file is being transferred
from the HAFM appliance hard drive,
or a data collection file is being
transferred to a CD. Informational message only—no action is
required.
Table 8 Element Manager messages (continued)
Message Description Action