LEICA SBP PRO 1 Lithium-Ion Battery for S Typ 007 (7.3V, 2300mAh) - Manual (Page 25)

EN
21
Basic camer
a se
ttings
Signal tones
With the Leica S you can decide whether messages or autofocus mode
should be confi rmed by acoustic signals, or whether the camera opera-
tion should be more or less silent. Two volumes can be selected.
The feedback is a beep tone that can be activated separately for autofo-
cus mode to indicate the completed setting and as a signal for a message
or warning.
Note:
In the factory setting the signal tones are deactivated.
Setting the functions
1. In the menu, under SETUP , select the item Acoustic Signals and
2. call up the sub-menu
It consists of the 3 items Volume , AF Confirmation and Warnings .
3. Under volume select Low or High
4. In the other sub-menus select whether or not you wish to activate the
tones for the respective functions
If you select On
With AF confi rmation a signal sounds as soon as the focus – whether
automatic or manual – is set correctly, i.e. together with the lighting up of
the corresponding display in the viewfi nder.
With Warnings a signal sounds together with all messages and warnings
displayed in the monitor, and on expiry of the self-timer.
If you select Off for Warnings
Even if you select Off , an acoustic warning signal is nevertheless given in
two situations:
– If the cover over the memory card slots is opened during data transfer
– When the shutter closes again at the end of the sensor cleaning pro-
cess
Monitor and top panel display
The Leica S has two displays,
– a black-and-white liquid-crystal display, and
– a large 3" liquid-crystal color monitor that is protected by a hard and
therefore very scratch-resistant glass cover.
The top panel display shows i.a. the most important basic information on
the status of the memory card(s) and the battery, and on the exposure
control (see "Displays in the top panel display", p. 61).
The monitor shows the complete image fi eld, along with the selected data
and information (see "Displays in the monitor", p. 62ff ). The brightness of
the monitor is controlled automatically, depending on the ambient bright-
ness. The sensor above the monitor is used for this function. Further-
more, its basic brightness can be adapted to the respective situation or to
your personal wishes.
Setting the functions
1. In the menu, under SETUP , select the item Display Brightness and
2. select the desired setting in the sub-menu
Monitor
Top panel display
Inhalt_EN.indd 21 12.10.2015 09:34:14