LEICA SBP PRO 1 Lithium-Ion Battery for S Typ 007 (7.3V, 2300mAh) - Manual (Page 64)

EN
60
The displa
ys
THE DISPLAYS
IN THE VIEWFINDER
1 2 3 5 6 9 7 8 12 10 11
6 12
4
1 Horizon
(Tilting about the longitudinal axis/inclination about the transverse axis;
values apply as examples for inclination in clockwise direction; other
directions are shown analogously)
– max. ±0.5°
– 0.5-2.5°
– 2.5-5°
– 5-10°
– flashing ≥10°
2 Shutter speed/exposure time
– Manually set value for and , automatically controlled value for
and ; display in half steps, or
– (high) or (low) for overexposure or underexposure in the
automatic exposure modes , , and by flash light, or for
values below the metering range.
– B setting for long exposures
– Warning message for full memory card(s)
3 Exposure operating mode
– Automatic program
– Aperture priority
– Shutter speed priority
– Manual setting of shutter speed and aperture
4 Aperture
Manually set value for and , automatically controlled value for
and ; display in half steps
5 Flash display
Lit Ready
Flashing Flash charging, not ready
6 Light scale
(Marks: each 1 ⁄
2
EV step, last marks/figures flash at ≤ -3EV/≥ +3EV )
to indicate
– Manual exposure compensation,
– Deviation of the current metering from the stored exposure setting
(with metered value storage in the automatic exposure modes ,
, )
– Exposure compensation
7 Flash display
Lit = Shutter speed set ≥ sync speed
8 Focus displays
– Appears only in manual mode or in the case of manual override
of the AF: Lights up continuously if the distance is set too far
– In manual mode: Lights up continuously with correct setting
– With AFs : Lights up continuously with correct setting, flashes
if correct setting is not possible,
– With AFc : Lights up continuously with correct setting, goes
out if focusing is restarted
– Appears only in manual mode or in the case of manual override
of the AF: Lights up continuously if the distance is set too short
9 Exposure compensation / flash exposure compensation set
10 Exposure metering method
– Multi-field metering
– Center weighted metering
– Spot metering
11 Picture counter
– Total remaining number of pictures
– External storage
– (flashing with 2 Hz) = Memory card full
– (flashing with 2 Hz) = No memory card inserted
– Maximum number for picture series
– Error message
12 ISO sensitivity
– For manual setting
– For automatic setting
– HI 1 (ISO3200) / HI 2 (ISO6400) / HI 3 (ISO12500)=
Currently set sensitivity
Note:
The viewfinder LCD is always lit when the camera is switched on. The
brightness of this lighting is automatically adapted to the ambient bright-
ness for optimum legibility.
Inhalt_EN.indd 60 12.10.2015 09:34:28