LEICA SBP PRO 1 Lithium-Ion Battery for S Typ 007 (7.3V, 2300mAh) - Manual (Page 59)

EN
55
Pr
ecautions and car
e ins
tructions
FOR THE CHARGER
• If the charger is used in the vicinity of radio receivers, it can interfere
with the reception; make sure there is a distance of at least 1m
between the devices.
• When the charger is in use, it can make a noise (buzzing) – this is quite
normal and is not a malfunction.
• When it is not in use, disconnect the charger from the mains as other-
wise it uses a certain (very small) amount of power even when no
battery is inserted in it.
• Always keep the charger contacts clean, and never short circuit them.
FOR MEMORY CARDS
• Whilst a picture is being stored or the memory card is being read, it
may not be removed, nor may the Leica S be turned off or exposed to
vibrations.
• For safety, memory cards should only ever be stored in the anti-
static cover supplied.
• Do not store memory cards where they will be exposed to high temper-
atures, direct sunlight, magnetic fields or static discharge.
• Do not drop or bend memory cards as this can damage them and
result in loss of the stored data.
• Always remove the memory cards if you will not be using the Leica S
for a longer period of time.
• Do not touch the connections on the memory card and keep them free
of dirt, dust and moisture.
• It is recommended that the memory cards are reformatted from time to
time, as fragmentation occurs when deleting, which can block some of
the memory capacity.
CLEANING THE SENSOR
If any dust or dirt particles should adhere to the sensor cover glass,
depending on the size of the particles this can be identified by dark spots
or marks on the pictures.
The Leica S can be returned to Leica Camera AG Customer Service
(address: see p. 67) for chargeable cleaning of the sensor; this cleaning is
not covered by warranty. You can also carry out cleaning yourself, using
the Sensor Cleaning function in the menu. This allows access to the
sensor by keeping the shutter open.
Notes:
• Generally: To protect the Leica S against ingress of dust etc. into the
interior of the camera, it is important always to have a lens or a cover
fitted to the camera body.
• For the same reason, when changing lenses work quickly and in an
environment that is as dust-free as possible.
• As plastic parts can easily pick up a static charge and then attract
more dust, individual lens caps and covers should only be stored for
short periods in pockets in clothing.
Setting the function
1. In the menu under SETUP , select ( Sensor Cleaning
• The relevant sub-menu appears.
2. Confirm with Yes
• The mirror is folded up and the shutter opens.
3. Carry out cleaning. Make sure you follow the instructions under
"Notes" below.
4. After cleaning, the shutter is closed again by turning off the camera.
• The message Please stop sensor cleaning immediately. is displayed.
Notes:
• This function is only available when the battery has at least 50% of its
full capacity. Otherwise a corresponding warning is displayed.
• As far as possible, both inspection and cleaning of the sensor should be
performed in a dust-free environment to prevent further soiling.
• An 8x or 10x magnifying glass is very helpful during the inspection
before and after cleaning.
• Lightly adhering dust can be blown off the sensor cover glass using
clean and, if necessary ionized gases such as air or nitrogen. It makes
sense to use a (rubber) bellows with no brush for this purpose. Special,
low pressure cleaning sprays such as "Tetenal Antidust Professional"
can also be used in line with their specified usage.
• If the particles cannot be removed in this way, please contact the Leica
Product Support department.
• If the battery capacity falls to lower than 40% while the shutter is open,
the warning message " Attention Please stop sensor cleaning immedia-
tely ." appears in the monitor. At the same time a continuous beep tone
will sound which can only be stopped by turning off the camera. Turn-
ing the camera off will cause the shutter to be closed again. Be abso-
lutely sure in this case that the shutter window is clear, i.e. that no
object can obstruct the closing movement of the shutter, otherwise
damage may occur.
Important:
• Leica Camera AG accepts no liability for damage caused by the user when
cleaning the sensor.
• Do not attempt to blow dust particles off the sensor cover glass using
your mouth; even tiny droplets of saliva can cause marks that are
difficult to remove.
• Compressed air cleaners with high gas pressure may not be used as
they can also cause damage.
• Take care to avoid touching the sensor surface with a hard object
during inspection and cleaning.
Storage
• If you will not be using the Leica S for a longer period of time, we
recommend that you
a. Switch it off (see p. 15),
b. Remove the memory cards (see p. 12), and
c. Take out the battery (see p. 11), (the entered time and date are lost
after max. 3 months, see p. 20).
• A lens acts like a magnifying glass if bright sunlight shines on the front
of the camera. The camera must therefore never be set aside in strong
sunlight without protection. Using the lens cover and keeping the
camera in the shade (or immediately putting it away in the case) help to
prevent damage to the interior of the camera.
• Store the Leica S in a dry, adequately ventilated place, where neither
high temperatures nor high humidity will occur. When used in humid
conditions, the Leica S should be completely free of all moisture before
being stored away.
• Photo cases that became wet during use should be emptied to prevent
damage to your equipment caused by moisture and any leather-tanning
residue released.
• To prevent fungal growth during use in hot, humid tropical climates, the
camera equipment should not be kept in air-tight containers for longer
than absolutely necessary. This is only recommended if a desiccant
such as silica gel is placed in the container
• To prevent the formation of fungus, do not store the Leica S in a leather
case for long periods of time.
• In a dry environment, store the Leica S preferably in a closed and
padded container so that nothing can rub against it and it is protected
from dust.
• Note the serial numbers of your Leica S and lenses, as these are
extremely important in case of loss.
Inhalt_EN.indd 55 12.10.2015 09:34:23