SkyTrak 6042 Service Manual - Manual (Page 90)

Boom
3.44 Model 6042 Legacy Origin 7/02
37. Use a hoist and slings to position the attachment tilt
cylinder (Fig. 3-95, 1) inside the gooseneck (2). Be
sure the attachment tilt cylinder is positioned with the
tube for the rod end positioned inside the
gooseneck.
38. Coat the base end pivot pin (Fig. 3-95, 3), saved,
with anti-seize compound. Align the hole in the
cylinder base end with the mounting holes in the
gooseneck and insert the pivot pin through the
gooseneck. Secure the pivot pin to the gooseneck
with the two retaining rings (4), saved. Be sure the
retaining rings are resting squarely in the grooves on
the pivot pin.
Figure 3-95 Attachment Tilt Cylinder Base End Pivot Pin
39. Coat the rod end pivot pin (Fig. 3 -96, 1), saved, with
anti-seize compound. Swing the rod end (2) of the
attachment tilt cylinder up and line up the rod end
with the mounting holes in the quick attach (3).
40. Insert the rod end pivot pin (Fig. 3-96, 1) through the
lined-up holes. Use a tapered punch to line up the
capscrew hole in the pivot pin and the mounting hole
in the quick attach hub. Insert the 1/2-13 x 5"
capscrew (4), saved, through the quick attach hub
from the backside and secure in place with a new
1/2-13 elastic locknut (5). Tighten securely.
Figure 3-96 Rod End Pivot Pin
41. Assemble the attachment tilt hoses from the
backside of the gooseneck to the fittings on the base
end of the attachment tilt cylinder. Assemble the left
side hose (Fig. 3 -97, 1) labeled as “Retract” to the
retract port (upper) fitting (2) on the base end of the
attachment tilt cylinder. Index the elbow end of the
hose to remove any undo tension and tighten the
elbow completely to the fitting on the cylinder.
MH0960
4
3
2
1
4
MH0940
5
2 4
1
3
~