Lenze E84DSxxx - Manual (Page 634)

15 Parameter reference
15.2 Parameter list | C02582
634
Lenze · 8400 protec StateLine · Reference manual · DMS 4.2 EN · 03/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Bit 1  [--]: nAct < nMin at CInh Brake response in case of pulse inhibit
• "1" ≡ In the case of a pulse inhibit, the actual speed
value is monitored which must reach the "Close"
threshold value to cause the holding brake to be
applied.
Note:
• This function is only active if bit 3
(horizontal/winding technology) is set as well. The
function is used in order that, when the controller is
inhibited, the holding brake of a drive with horizontal
traverse path does not wear out during rotation.
• With vertical motion (bit 3 = 0), this function is not
active. Especially with hoists and activated pulse
inhibit of the controller, an immediate application of
the brake is essential for safety-related reasons!
Bit 2  [||]: Feedforward control inverted Direction of feedforward control with vertical/hoist
technology:
• "0" ≡ Positive direction
• "1" ≡ Negative direction
Note:
Reversal (Ccw) is then considered.
Bit 3  [--]: Horizontal Direction of movement of the axis
• "0" ≡ The axis performs vertical movements.
Gravitational acceleration causes movements.
• "1" ≡ The direction of the axis is horizontal or rotary.
The gravitational acceleration does not cause any
movement.
Bit 4  Reserved
Bit 5  Reserved
Bit 6  Sync ramp L_NSet_1
From version 11.00.00
Selection of the ramp time for the synchronisation
process to setpoint speed after the brake opening time
has elapsed
Revised behaviour from version 11.00.00:
• "1" ≡ The ramp time of the effective acceleration of
the ramp function generator ( L_NSet_1 ) is used
(Lenze setting).
• "0" ≡ As before, the ramp time set in C02610/1 is used.
Note:
The changeover can be dynamically both via the ramp
parameter and via bit 6.
Bit 7  Reserved
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT
Parameter | Name:
C02582 | Holding brake: Setting
Data type: UNSIGNED_8
Index: 21993
d
= 55E9
h