Ce compliance, Ec directive compliance, Emc directive – Rockwell Automation 193-EC1_2_3_5, 193-ECPM,592-EC1_2_3_5 E3 and E3 Plus Solid-State Overload Relay User Manual User Manual
Page 269: Ec directive compliance emc directive, Appendix
Rockwell Automation Publication 193-UM002I-EN-P - December 2011
269
Appendix
C
CE Compliance
The E3 Overload Relay is intended for use in a heavy industrial environment. It is
CE marked for conformity to the Low Voltage Directive 73/23/EEC (as
amended by 93/68/EEC) and the EMC Directive 89/336/EEC (as amended by
92/31/EEC and 93/68/EEC) when installed as described in this manual.
EC Directive Compliance
To obtain a copy of the E3 Overload Relay’s Declaration of Conformity (DoC),
contact your local Rockwell Automation sales office or Allen-Bradley distributor
or go to http://www.ab.com/certification/#CEmark.
EMC Directive
This product is tested to meet Electromagnetic Compatibility (EMC) Directive
89/336/EC, as amended by 92/31/EEC and 93/68/EEC, by applying the
following standards (in whole or in part), and as documented in a technical
construction file:
• EN 60947-4-1 – Low Voltage Switchgear and Control Gear; Part 4 –
Contactors and Motor Starters, Section 1 – Electromechanical Contactors
and Motor Starters
• EN 60947-5-1 – Low Voltage Switchgear and Control Gear; Part 5 –
Control Circuit Devices and Switching Devices, Section 1 –
Electromechanical Control Circuit Devices
IMPORTANT The conformity of the E3 Overload Relay to these standards does not
guarantee that an entire installation will conform. Many other factors
can influence the entire installation and only direct measurements can
verify total system conformity. It is therefore the responsibility if the
installer to ensure system conformity.
IMPORTANT The grounding requirements specified in this manual must be followed by
the installer in order for the product to comply with the EMC directive.
ATTENTION: This is a Class A (heavy industrial) product. In a Class B
(light industrial or domestic) environment, this product may cause radio
interference in which case the installer may be required to take additional
measures to mitigate it.