Great Plains Raven 440 - Manual (Page 41)

5
Manual No. 016-0159-822 37
Console Programming and Calibration
Data Lock Feature
The Data Lock feature prohibits data entry without the data-lock code. The four-digit code must be entered
within 15 seconds.
Activate the Data Lock Code
1. Press the DATA MENU button until the message “PRESS ENTER FOR DATA-LOCK” appears on the
console’s display.
2. Press ENTER. The message “NEW CODE E” will appear in the display.
3. Enter the 4-digit data lock code of your choice within 15 seconds.
4. Press ENTER.
Change the Data Lock Code
1. Press the DATA MENU button until the message “PRESS ENTER FOR DATA-LOCK” appears on the
console’s display.
2. Press ENTER. The message “OLD CODE E” will appear in the display.
3. Enter the old 4-digit data lock code within 15 seconds.
4. Press ENTER. The message “NEW CODE E” will appear in the display.
5. Enter the new 4-digit code within 15 seconds, or enter 0 to disable the Data-Lock feature.
6. Press ENTER.
Entering Data in the Data Lock Mode
1. Press the button of the variable to be edited.
2. Press ENTER. A message prompting for the data-lock code will appear.
3. Enter the data-lock code. If the code is correct, E will appear on the display.
4. Enter the data to be changed as usual.
Clear the Data-Lock Code
The Data-Lock feature may be disabled so that a data-lock code is not required in one of two ways. The code
can be changed to 0 as outlined in the Change the Data Lock Code section on page 37, or the console can be
reset, clearing the data-lock code from the system.
Important: All calibration values entered into the SCS 440 console will be lost and must be reprogrammed.
To reset the console:
1. Turn the POWER ON/OFF switch to the OFF position.
2. Press CE and hold while turning the POWER ON/OFF switch to the ON position.