Replacing ram – VXL Instruments Itona Md75 Series User Manual
Page 12
Advertising
Replacing RAM
8
5
Replacing RAM
1. Remove the power cord and top cover as described on page 5.
2. Apply isopropyl alcohol on the glue holding the DDR3 RAM; pull the glue out using nose
pliers.
Figure 5-1: RAM Socket Clips
3. Remove the existing RAM from the SO-DIMM slot by unlocking the holders and pulling it
outward.
Figure 5-2: Removing the RAM Module
4. Place the new DDR3 RAM in the SO-DIMM slot.
Note: Ensure that the new RAM is of the same specification as the existing RAM.
5. Slide the RAM into place until the clip snap-fits at each end of the SO-DIMM socket.
Advertising