Replacing the flash – VXL Instruments Itona Md75 Series User Manual
Page 14
Advertising
Replacing the
Flash
10
6
Replacing the Flash
1. Remove the power cord and top cover as described on page 5.
2. Using the star screwdriver, remove the two screws holding the Solid State Drive (SSD).
3. Gently pull the SSD from the socket, as shown in Figure 6-1.
Figure 6-1: Removing the SSD
4. Place the new SSD in the socket and press to snap-fit.
Note: Ensure that the new SSD is of the same specification and has the correct software
image installed on it.
5. Replace the top cover as described on page 5 and connect the external cables.
Advertising