H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 205)

191
Figure 89 Network diagram
NOTE:
•
Configure IP addresses for the client, server, and ACs as shown in Figure 89 and make sure that they
have IP connectivity between each other.
• Make sure that the client can access the authentication server through AC 1 and AC 2 respectively.
• On the authentications server, specify the access device's IP address as the virtual IP address of the VRRP
group. For more information about VRRP, see
High Availability Configuration Guide.
• For information about stateful failover configuration, see High Availability Configuration Guide.
• You must use consistent device roles for AC stateful failover and VRRP. If you use an AC as the master for
stateful failover, use the AC as the master in a VRRP group, too. Otherwise, in local portal
authentication, the access device cannot push authentication pages according to the SSID. If your
network cannot meet the requirement, for example, the two ACs are configured for load balancing,
related portal-free rules should be configured.
Configuring the portal server on IMC PLAT 3.20
NOTE:
This example assumes that the portal server runs on IMC PLAT 3.20-R2602P13 and IMC UAM
3.60-E6301.
1. Configure the portal server:
a. Log in to IMC and click the Service tab.
b. Select Portal Service Management > Server from the navigation tree to enter the portal server
configuration page, as shown in
Figure 90 .
AC 1
Failover link
Client
IP: 9.9.1.2/24
Gateway: 9.9.1.1/24
AC 2
Vlan-int10
9.9.1.5/24
Vlan-int10
9.9.1.6/24
GE 1/0/1
Vlan-int20
192.168.0.6/24 GE 1/0/1
Vlan-int20
192.168.0.5/24
VLAN8
Virtual IP address :
192.168.0.1/24
Server
192.168.0.111/24
Master Backup
L3 switch
Gateway：9.9.1.1/24
AP
1.1.1.3/24
VLAN8
L2 switch
Vlan-int2
1.1.1.1 Vlan-int2
1.1.1.2