H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 28)

14
No. Attribute Description
61 NAS-Port-Type
Type of the physical port of the NAS that is authenticating the user. Possible
values are as follows:
• 15—Ethernet
• 16—Any type of ADSL
• 17—Cable (with cable for cable TV)
• 19—Wireless-IEEE 802.11
• 201—VLAN
• 202—ATM
If the port is an ATM or Ethernet one and VLANs are implemented on it, the value
of this attribute is 201.
79 EAP-Message
Used for encapsulating EAP packets to allow the NAS to authenticate dial-in
users via EAP without having to understand the EAP protocol.
80
Message-Authentic
ator
Used for authentication and checking of authentication packets to prevent
spoofing Access-Requests. This attribute is used when RADIUS supports EAP
authentication.
87 NAS-Port-Id String for describing the port of the NAS that is authenticating the user.
H3C proprietary RADIUS sub-attributes
No. Sub-attribute Description
1 Input-Peak-Rate Peak rate in the direction from the user to the NAS, in bps.
2 Input-Average-Rate Average rate in the direction from the user to the NAS, in bps.
3 Input-Basic-Rate Basic rate in the direction from the user to the NAS, in bps.
4 Output-Peak-Rate Peak rate in the direction from the NAS to the user, in bps.
5 Output-Average-Rate Average rate in the direction from the NAS to the user, in bps.
6 Output-Basic-Rate Basic rate in the direction from the NAS to the user, in bps.
15 Remanent_Volume
Remaining, available total traffic of the connection, in different units for
different server types.
20 Command
Operation for the session, used for session control. It can be:
• 1—Trigger-Request
• 2—Terminate-Request
• 3—SetPolicy
• 4—Result
• 5—PortalClear
24 Control_Identifier
Identification for retransmitted packets. For retransmitted packets of the same
session, this attribute must take the same value. For retransmitted packets of
different sessions, this attribute may take the same value. The client response
of a retransmitted packet must also carry this attribute and the value of the
attribute must be the same.
For Accounting-Request packets of the start, stop, and interim update types,
the Control-Identifier attribute is ineffective.
25 Result_Code
Result of the Trigger-Request or SetPolicy operation. A value of zero means
the operation succeeded, and any other value means the operation failed.