HEIDENHAIN TNC 128 (77184x-02) - Manual (Page 323)

Graphics 13.1
13
TNC 128 | User's Manual HEIDENHAIN Conversational Programming | 5/2014
323
Rotating, enlarging, reducing and shifting the 3-D view
Select the functions for rotating and enlarging/
reducing: The TNC displays the following soft keys:
Function Soft keys
Rotate in 5° steps about the vertical axis
Tilt in 5° steps about the horizontal axis
Enlarge the graphic stepwise
Reduce the graphic stepwise
Reset the graphic to its original size
Shift the soft-key row
Function Soft keys
Move the graphic upward or downward
Move the graphic to the left or right
Reset the graphic to its original position
If there is a mouse attached to your TNC, you can also perform the
functions described above with the mouse:
In order to rotate the graphic shown in three dimensions: Hold
the right mouse button down and move the mouse. After you
release the right mouse button, the TNC orients the workpiece
to the defined orientation
In order to shift the graphic shown: Hold the center mouse
button or the wheel button down and move the mouse. The
TNC shifts the workpiece in the corresponding direction. After
you release the center mouse button, the TNC shifts the
workpiece to the defined position
In order to zoom in on a certain area with the mouse: Mark a
zoom area by holding the left mouse button down. After you
release the left mouse button, the TNC zooms in on the defined
area of the workpiece
In order to quickly zoom in and out with the mouse: Rotate the
wheel button forward or backward