HEIDENHAIN iTNC 530 (606 42x-02) - Manual (Page 691)

HEIDENHAIN iTNC 530 691
1
8
.1 Gener
a
l User P
a
ra
met
e
rs
Select the "Program
Run" mode of
operation: Display of
multi-tiered NC blocks MP7281.1
Always show all NC blocks completely: 0
Only show current block completely: 1
Only show NC block completely when editing: 2
Position display in the
tool axis MP7285
Display is referenced to the tool datum: 0
Display in the tool axis is referenced to the
tool face: 1
Display step for the
spindle position MP7289
0,1 °: 0
0,05 °: 1
0,01 °: 2
0,005 °: 3
0,001 °: 4
0,0005 °: 5
0,0001 °: 6
Display step MP7290.0 (X axis) to MP7290.13 (14th axis)
0.1 mm: 0
0.05 mm: 1
0.01 mm: 2
0.005 mm: 3
0.001 mm: 4
0.0005 mm: 5
0.0001 mm: 6
Disable datum setting
in the preset table MP7294
Do not disable datum setting: %00000000000000
Disable datum setting in the X axis: Bit 0 = 1
Disable datum setting in the Y axis: Bit 1 = 1
Disable datum setting in the Z axis: Bit 2 = 1
Disable datum setting in the IVth Disable axis: Bit 3 = 1
Disable datum setting in the Vth axis: Bit 4 = 1
Disable datum setting in the 6th axis: Bit 5 = 1
Disable datum setting in the 7th axis: Bit 6 = 1
Disable datum setting in the 8th axis: Bit 7 = 1
Disable datum setting in the 9th axis: Bit 8 = 1
Disable datum setting in the 10th axis: Bit 9 = 1
Disable datum setting in the 11th axis: Bit 10 = 1
Disable datum setting in the 12th axis: Bit 11 = 1
Disable datum setting in the 13th axis: Bit 12 = 1
Disable datum setting in the 14th axis: Bit 13 = 1
TNC displays, TNC editor