HEIDENHAIN TNC 640 (34059x-01) Cycle programming - Manual (Page 27)

HEIDENHAIN TNC 640 27
14.1 General Information about Touch Probe Cycles ..... 368
Method of function ..... 368
Consideration of a basic rotation in the Manual Operation mode ..... 368
Cycles in the Manual and El. Handwheel modes ..... 368
Touch probe cycles for automatic operation ..... 369
14.2 Before You Start Working with Touch Probe Cycles ..... 371
Maximum traverse to touch point: DIST in touch probe table ..... 371
Set-up clearance to touch point: SET_UP in touch probe table ..... 371
Orient the infrared touch probe to the programmed probe direction: TRACK in touch probe table ..... 371
Touch trigger probe, probing feed rate: F in touch probe table ..... 372
Touch trigger probe, rapid traverse for positioning: FMAX ..... 372
Touch trigger probe, rapid traverse for positioning: F_PREPOS in touch probe table ..... 372
Multiple measurements ..... 372
Confidence interval of multiple measurements ..... 372
Executing touch probe cycles ..... 373
14.3 Touch Probe Table ..... 374
General information ..... 374
Editing touch probe tables ..... 374
Touch probe data ..... 375
14 Using Touch Probe Cycles ..... 367