HEIDENHAIN TNC 640 (34059x-01) Cycle programming - Manual (Page 334)

334 Cycles: Turning
13.1
7 RADIAL RECESSING EXTENDED (Cy
c
le 862)
Cycle parameters
U Machining operation Q215: Define the machining
operation:
0: Roughing and finishing
1: Only roughing
2: Only finishing to finished dimension
3: Only finishing to oversize
U Set-up clearance Q460: Reserved, currently without
function
U Diameter at contour start Q491: X coordinate of the
contour starting point (diameter value)
U Contour start in Z Q492: Z coordinate of the contour
starting point
U Diameter at end of contour Q493: X coordinate of
the contour end point (diameter value)
U Contour end in Z Q494: Z coordinate of the contour
end point
U Angle of side Q495: Angle between the side at the
contour starting point and the perpendicular to the
rotary axis
U Starting element type Q501: Define the type of the
element at the contour start (circumferential surface):
0: No additional element
1: Element is a chamfer
2: Element is a radius
U Size of starting element Q502: Size of the starting
element (chamfer section)
U Radius of contour edge Q500: Radius of the inside
contour edge. If no radius is specified, the radius of
the cutting insert is generated.
U Angle of second side Q496: Angle between the side
at the contour end point and the perpendicular to the
rotary axis
U Type of end element Q503: Define the type of the
element at the contour end:
0: No additional element
1: Element is a chamfer
2: Element is a radius
U Size of end element Q504: Size of the end element
(chamfer section)