Intel STL2 - Manual (Page 94)

Regulatory and Integration Information STL2 Server Board TPS
8-86
• Intel’s UL File Number E139761 (Component side).
• Battery “+” marking: located on the component side of the board in close proximity to
the battery holder.
•
CE Mark: (Component side)
•
Australian C-Tick Mark: Consists of solid circle with white check mark and supplier code
N232.
• Russian GOST (Open letter “C” with the letter “P” inside the “C” and the letter “T” in the
mouth of the “C”.
• Taiwan BSMI Certification mark. Two Chinese characters and an 8 digit number.
8.2 Installation Instructions
CAUTION: Follow these guidelines to meet safety and regulatory requirements when installing
this board assembly.
Read and adhere to these instructions and to the instructions supplied with the host computer
and associated modules. If the instructions for the host computer are inconsistent with these
instructions or the instructions for associated modules, contact the supplier’s technical support
to find out how to ensure that the system meets safety and regulatory requirements. If the
instructions are not followed, the user increases safety risk and the possibility of
noncompliance with regional laws and regulations.
8.2.1 Ensure EMC
Before computer integration, the host chassis, power supply, and other modules should pass
EMC certification testing.
In the installation instructions for the host chassis, power supply, and other modules, pay close
attention to the following:
• Certifications.
• External I/O cable shielding and filtering.
• Mounting, grounding, and bonding requirements.
• Keying connectors when mismating of connectors could be hazardous.
If the host chassis, power supply, and other modules have not passed applicable EMC
certification testing before integration, EMC testing must be conducted on a representative
sample of the newly completed computer.
8.2.2 Ensure Host Computer and Accessory Module Certifications
The host computer and any added subassembly (such as a board or drive assembly, including
internal or external wiring) should be certified for the region(s) where the end product will be
used. Marks on the product are proof of certification. Certification marks are as follows: