Olympus IX2-DSU BX-DSU - Manual (Page 68)

ASSEMBLY
/ IN/OUT of rear side turret
II. DSU
II . 8 - 1 4 Page
8-11 IN/OUT of rear side turret
When you install or detach the turret, you must do the works
after you turn the power of control box.
1. (Removal). Loosen screws (2) (2 places) at rear side of access panel (1) on
top of disk box, using dedicated the Allen screwdriver and remove the access
panel.
2. Loosen fixing screw from hole (3) located at left side of disk box, using The
Allen screwdriver and hold the handle (4) of turret and pull it upward.
Pull out the turret gently so as not to hit mirror unit with inside
wall of disk box.
3. (Installation). Align mount dovetail of turret and mount dovetail of disk box and
push the turret from top until it hits to dead end.
4. Tighten fixing screw (3), using the Allen screwdriver.
5. Attach access panel (1) on top of disk box and tighten fixing screws (2) (2
places), using the Allen screwdriver.
8-12 Installation of camera mirror unit (rear side)
1. Loosen fixing screw (1), using the Allen screwdriver and
remove dummy mirror unit (2).
When mirror units already exist inside the
cassette, be careful so as not to touch dichroic
mirror or excitation filter with your finger.
Reference mirror of adjustment completed is
attached at No.1 position. Do not change the
position of this reference mirror.
2. Insert mirror unit (3) to be used into mount dovetail (4) of
mirror unit and push it until it hits to dead end and the, tighten
fixing screw (1), using the Allen screwdriver.
Note
Note
Note
Note
(1)
(2)
(3)
(4)
(1)
(2)
(3)
(4)