Olympus IX2-DSU BX-DSU - Manual (Page 70)

ASSEMBLY
/ Installation of light shielding tube (BX61, BX62, BX51 or BX52)
II. DSU
II . 8 - 1 6 Page
6. Set the disk, putting the side attached with name seal (dark blue
side) down and, holding edge of disk, turn rotary shaft (7) in counter-
clockwise direction to screw in to the end, using the Allen screwdriver.
After fixing, remover the wrapper.
If you install disk upside down, cover (6) would not
close. If you attempt to close cover (6), it would
damage surface of disk. Therefore, attach the disk in
correct direction.
7. Return disk cover (6) to original position and tighten knob (5) of disk
unit (2 places) and fix the cover.
8. The disk removed should be kept in the packet. Transport lock knob
should be attached to the disk unit.
9. Align dovetail of disk unit (4) and dovetail of disk box (8) and push it
from top to dead end.
10. Tighten fixing screw (3), using the Allen screwdriver.
11. Attach access panel (1) on top of disk box and tighten fixing screws
(2) at two places, using the Allen screwdriver.
8-14 Installation of light shielding tube (BX61, BX62, BX51 or BX52)
1. Remove front side turret. For removal of front side turret, see 8-9
Installation of front side turret.
2. Set light shielding tube inside the light illuminator.
(1)
Note
(6)
(7)
(5)
(both sides)