Sk series – General Pump SK Repair Manual User Manual
Page 17
Advertising
GENERAL PUMP
A member of the Interpump Group
SK SERIES
Lock the three assemblies using the special device (part #F27566200) (1, fig. 41). Insert the crankshaft
through the rear opening of the casing and lay it on the bottom.
The crankshaft must be inserted into the casing so that the teeth on the ring bevel gears are
oriented as shown in fig. 52
Page 17
Pre-assemble the PTO shaft.
Onto the PTO shaft, slip on the 2 internal rings of the bearings (one per side) (1, fig. 53).
The internal and and external bearing rings must be reassembled in exactly the same order
and pairings in which they were dismantled.
Advertising