Sk series – General Pump SK Repair Manual User Manual
Page 26
Advertising
GENERAL PUMP
A member of the Interpump Group
SK SERIES
Page 26
Repeat the operation on the other side.
Remove the M16 screw from the crankshaft. Screw the two bushing locking flanges onto the crankshaft using
4 M12 x 25 screws (1, fig. 89).
Apply LOCTITE 243 to the threads of the M12 x 25 screws (1, fig. 88).
Set the screws with a torque wrench, as shown in Section 3.
Measure the distance X indicated in fig. 86 between the conical bushing and the crankshaft bearing.
Screw in the M16 screw until there is a reduction in the distance X of between 0.7 mm and 0.8 mm (fig. 97).
Advertising