General Pump SK Repair Manual - Manual (Page 8)

GENERAL PUMP
A member of the Interpump Group
SK SERIES
Remove the shim from under the shank of the central connecting rod. Unscrew the connecting rod screws
(1, fig. 18).
Advance the three big end halves as far as possible in the direction of the head. Slip off the three upper half-
bearings of the big end halves (1, fig. 20).
Dismantle the small ends of the connecting rods with the half-bearings. During this operation take particular
care to not the order in which the parts are removed.
The connecting rod small ends and the big end halves must be reassembled in exactly the
same order and pairings in which they were dismantled.
To prevent any errors, small ends and big end halves are numbered on one side (1, fig. 19).
Page 8