Sk series – General Pump SK Repair Manual User Manual
Page 23
Advertising
GENERAL PUMP
A member of the Interpump Group
SK SERIES
Page 23
Fasten the bearing support covers with 6 M10 X 30 screws (1, fig. 75).
Set the screws with a torque wrench, as shown in Section 3.
Partially insert the two pressure bushings, keeping the crankshaft lifted up by means of the previously-
mounted M16 pin (1, fig. 76).
Insert the pressure bushing completely onto the crankshaft (1, fig. 77 and fig. 78) using a mallet/striking
hammer and a pad.
Advertising