Sk series – General Pump SK Repair Manual User Manual
Page 18
GENERAL PUMP
A member of the Interpump Group
SK SERIES
From one side of the casing, insert the bearing lubrication (1, fig. 54) and an external bearing ring
(1, fig. 55) using a pad and a mallet or striking hammer).
Page 18
Remove the device for locking the connecting rods (part #F27566200) (1, fig. 41) and roll back the
connecting rods until they touch the crankshaft
Insert the pre-assembled PTO shaft into the casing (1, fig. 56). Insert it from the other side to the side where
the external bearing ring and the bearing lubrication bushing were inserted.
The PTO shaft must be inserted into the casing so that the teeth are oriented as shown in
fig. 56.
It is easier to insert the PTO shaft completely inside the bearing by applying the M16 screw to the end of the
shaft being inserted, to keep the shaft lifted up (1, fig. 57).