IDEC DATAVS1 Series User Manual
Page 24
Instruction Manual
SVS1 Series
19
5.5.
Step 2 - Configuration of the selected inspection tool
In step 2 of the configuration process you will define the settings which will regulate the inspection tool
selected in step 1.
The configurator display is basically organised as seen in step 1. The settings that the user can modify
are displayed on the right, whilst the rest of the screen displays the image acquired by the sensor. The
name of the current setting is also displayed at the bottom of the screen, with a brief description of the
same and the current values.
Settings are displayed one at a time. To move from one setting to another, use the LEFT/RIGHT
ARROW
buttons. To adjust the current setting, use the UP/DOWN ARROW buttons. By pressing the
button, the value will increase/decrease by one unit. To modify the value faster, press and hold the
button.
The settings in this section vary according to the selected inspection tool. Please refer to Chapter 7 for
further details.
Once the settings have been completed, it is possible to proceed to the next stage by pressing the
STATUS
button. The Adjust LED switches off and the Monitor LED lights up.
Field size
Calculated value
Current settings value
Settings name
Description