HP StorageWorks 2.140 Director Switch - Manual (Page 214)

Informational and error messages 218
Cannot display route. All
switches in route must
support routing.
You cannot show the
route through a fabric that
has switches or directors
which do not support
routing.
The route must contain only Edge
Switch 2/16s, Edge Switch 2/32s,
Director 2/64s, or Director
2/140s.
Cannot display route.
Device is not a member of
a zone in the active zone
set.
You cannot show the
route for a device that is
not a member of a zone
in the active zone set. The
source node that you
have selected is not part
of a zone in the active
zone set.
Enable the default zone or activate
the zone for the device before
attempting to show the route.
Cannot display route on
one switch fabric.
You cannot show routes
between end devices in a
fabric when configuring
Show Routes (Configure
menu).
Error is displayed when attempting
to show routes on a fabric with only
one switch. Configure Show Routes
on a multiswitch fabric.
Cannot display route.
error 9.
An internal error has
occurred while trying to
view routes.
Contact the next level of support to
report the problem.
Cannot display route. No
active zone enabled.
You cannot show the
route through a fabric
with no active zone.
Enable the default zone or activate
a zone set before attempting to
show the route.
Cannot have spaces in
field.
Spaces are not allowed
as part of the entry for
this box.
Delete spaces from the box entry.
Cannot modify a zone set
with an invalid name.
Rename zone set and try
again.
A zone set must have a
valid name to be
modified.
Assign a valid name to the zone
set, then modify the name through
the Modify Zone Set dialog box.
Cannot modify a zone
with an invalid name.
Rename zone and try
again.
A zone must have a valid
name to be modified.
Assign a valid name to the zone,
then modify the name through the
Modify Zone Set dialog box.
Table 30 HAFM Messages (continued)
Message Description Action