HP StorageWorks 2.140 Director Switch User Manual

Page 232

Advertising
background image

Informational and error messages

236

Cannot install firmware to

a switch with a failed CTP

card.

Firmware cannot be

installed on a switch with

a defective CTP card.

Note that the CTP card is not a

FRU. If it fails, the switch must be

replaced. After replacement, retry

the firmware install to the switch.

Cannot modify

director/switch speed.

Ports speeds cannot be

configured at a higher

data rate than the

director/switch speed.

Port speeds cannot be

configured at a higher

data rate than the

director speed. This

message is displayed

when you set director

sped to 1 GB/sec

through the Configure

Switch Parameters dialog

box and at least one of

the ports is running at 2

Gb/sec.

Either return the director speed to 2

Gb/sec or configure all port data

speeds to 1 Gb/sec through the

Configure Ports dialog box.

Cannot perform this

operation while the switch

is offline.

This operation cannot

take place while the

director or switch is

offline.

Configure the director or switch

offline through the Set Offline State

dialog box and then retry the

operation.

Cannot retrieve current

SNMP configuration.

The director SNMP

configuration cannot be

retrieved by the Element

Manager because the

Ethernet link is down or

busy.

Retry the operation later. If the

condition persists, contact the next

level of support.

Cannot retrieve

diagnostics results.

Director diagnostic results

cannot be retrieved by the

Element Manager

because the Ethernet link

is down or busy.

Retry the operation later. If the

condition persists, contact the next

level of support.

Cannot retrieve

information for port.

Port information cannot

be retrieved by the

Element Manager

because the Ethernet link

is down or busy.

Retry the operation later. If the

condition persists, contact the next

level of support.

Cannot retrieve port

configuration.

The port configuration

cannot be retrieved by the

Element Manager

because the Ethernet link

is down or busy.

Retry the operation later. If the

condition persists, contact the next

level of support.

Table 31

Element Manager messages (continued)

Message

Description

Action

Advertising