HP StorageWorks 2.140 Director Switch User Manual
Page 235
HA-Fabric Manager user guide 239
Cannot set all ports to
Negotiate due to port
speed restriction on some
ports.
Displays if you try to set
all ports to Negotiate
through the Configure
Ports dialog box and
some ports do not
support speed
configuration.
Replace ports that do not support
speed configuration with those that
do support more than one speed
configuration.
Cannot set Fibre Channel
parameters.
Fibre Channel parameters
for the director cannot be
set at the Element
Manager because the
Ethernet link is down or
busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Cannot set switch date
and time.
The switch date and time
cannot be set at the
Element Manager
because the Ethernet link
is down or busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Cannot set switch state.
The director or switch
state cannot be set at the
Element Manager
because the Ethernet link
is down or busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Cannot set write
authorization without
defining a community
name.
A community name was
not defined in the
Configure SNMP dialog
box for the write
authorization selected.
Provide a name in the Name box
where write authorization is
checked.
Cannot start data
collection.
The data collection
procedure cannot be
started by the Element
Manager because the
Ethernet link is down or
busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Cannot start firmware
install while CTP
synchronization is in
progress.
The director’s CTP cards
are synchronizing and
firmware cannot be
installed until
synchronization is
complete.
Install the firmware after CTP card
synchronization completes.
Table 31
Element Manager messages (continued)
Message
Description
Action