Vinpower Digital Titan Lightscribe Autoloader - Manual (Page 58)

56
Appendix A - Installing 3rd Spindle on 100 Discs Capacity Model
Due to shipping precautions Spindle 3 is not pre-attached to the autoloader. Spindle 3 easily attaches to the
right of Spindle 2 (see Figure 1-4) and for your convenience we have pre-drilled the necessary screw holes.
The only tool you will need is a Philips screw driver. Please make sure the contents of the carton match.
Contact your vendor if there are any damaged, missing or incorrect parts.
Parts Included:
Short Philips Screw x 4pcs
Long Philips Screw x 4pcs
Supporting Base/Bracket, 1pc
Disc Spindle, 1pc
Tools Required (Not Included):
Philips Screw Driver
Step 1: Align the pre-drilled screw holes with the screw holes on the Supporting Base/Bracket. Use the 4
Short Philips Screws to fasten the bracket into place, 2 on the side and 2 on top.
Note: there are 3 pre-drilled holes on Top of the base; the 2 small screws will go into the outer holes,
leaving the center one free.
Step 2: Align the base of the Spindle with the 4 holes on the top of the Supporting Base/Bracket. Mount it by
screwing in the 4 Long Philips Screws into the corresponding 4 holes in the base.
Step 3: Boot up the system and change the “Robot Capacity” setting to 200 by performing the below
operation:
 Press Up or Down button to “Loader Utilities” menu
 Press ENT/Enter button once to enter the menu.
 Press Up or Down button to “Robot Capacity”
 Press ENT/Enter button once to enter the setting.
 Press Up or Down button to set it to 200.
 Press ENT/Enter button once to enter the setting.
 Systems will automatically restart to apply the change. If not, then you may need to recycle the
power manually for the update to take effect.