LulzBot TAZ Pro S 3D Printer - Manual (Page 29)

LulzBot TAZ Pro S | 27
5
Preparing to Print
5.9 Push the filament by hand completely through the feed tube until it exits near the filament guide tube
holder on the top of the extruder. Straighten the filament slightly and place your thumb on the filament
tension knob and pull the lever away from the filament feed path . Feed the included sample coil of 1.75mm
PLA filament into the extruder.
The filament must be inserted
into the dual hob gears for
filament to extrude properly. If
it is difficult to feed filament into
the filament feed path, trimming
the filament at a 45° angle may
help.
!
45°